I know this isn’t a problem with Audacity, but like mentioned, I didn’t know where else to ask this question. The first virtual audio cable control panel shows and internal samplerate at 96 kHz, please set it to 44100 or 48000: 1- run the control panel in administrator mode. That’s all.OBS will connect to the selected hardware. There are plenty of virtual cable solutions out there like Virtual Audio Cable (VAC), but I chose VB-Audio Virtual Cable on this one as a free alternative. Our algorithm gave the review of a relatively high score. I tried using only one mic, with just FL in case Virtual Audio Cable couldn’t see the difference between the mics, but here the audio still outputs the sound to both speakers. Re: Audio Choppy when using Virtual Cables. Click on voice.ai ( VB- Audio virtual cable) under the Mic/ auxiliary audio and Click ok. is very likely not a scam but legit and reliable. In theory I think that that should work, but they both still output to both speakers. VB Cable works like an audio cable in the real world the audio of selected apps, like Zoom or Skype goes to the input of VB Audio Cable, which is plugged. In Virtual Audio Cable on Channel Config I set it to custom and use FL for one and FR for the other, and then use the same Line for wave out. But, in order to get more control over the levels in post production, I would like to record the two different mics on two different sound channels, i.e one through the left speaker and one through the right speaker. I have restarted the computer a number of times however I am still unable to get any audio thru virtual cable. It would appear that for some reason Radioboss is not routing the signal to the Main (On Air) soundcard nor the Monitor Soundcard. I am without any problems able to combine the two mics into one output to record. I have installed Virtual Audio Cable and in the Virtual Cable panel, not input is shown. After installing the VB-CABLE driver, a new playback device will appear in the. I don’t know if anyone here has any experience with Virtual Audio Cable, but since it doesn’t have it’s own forum I couldn’t think of any other place to ask this. VB-Audio CABLE is a Windows Audio Driver that works like a virtual audio cable. I have a podcast, and I need to record two microphones on the same computer, which is possible using Virtual Audio Cable.
0 Comments
Leave a Reply. |